The GET MD3 Pro is a fully scalable dashboard logger system for professional users who need a fully customisable data acquisition system. The MD3 PRO device offers some more functions compared to the SERIES version, e.g. extra analog and digital inputs, extra CAN port, and more.
This unique dash data system is made with cutting edge technology but remains very user friendly.
Thanks to GPS, the system allows building the track in 2 dimensions, viewing trajectories, recording lap time, intermediates and speed without any additional sensor, beacon or transponder.
Data can be shown directly onto the dashboard or they can alternatively be downloaded into your computer for analysis with our MX2 software.
The MD3 PRO is ideal for any motorsport application: cars, formula, motorbikes, karting, speed-boating, and many more. The MD3 PRO has a billet aluminium case and is equipped with a Deutsch AS 55-pin connector allowing a fully customisable setup.
Our innovative MX2 Software allows in-depth and efficient analysis of recorded data.
This dash is supplied with mating Deutsch AS connector, universal mounting bracket, USB communication cable and software manuals & install disk.
Technical features
• View all data as once available on the replaced dashboard
• View error messages from the stock logger.
• Original signals and alarms such as indicators – alarms – temperature - fuel level - speed countergear
(See specific technical sheet)
• Lap timer showing lap time and up to 4 intermediates (with GPS setup)
• Best time and best intermediate led.
• Current lap number.
• Gear change led with user thresholds.
• View on-board sensors data acquisition with flexible graphical view.
• GPS-based speed. This means that speed data are not influenced by wheel blocking or skidding, or by bend inclination. No sensor needed.
• Backlight.
• Recording capacity: 100 tracks;
• Track drawing with GPS. Finish line and sector settings on the dashboard. Any track can be easily recorded.
• Session reports showing timing, sectors, Theoretical best lap, min and max value for each value.
• Dashboard-based sensor calibration;
• 12 analog inputs single-ended 0…5V to 12 bit (protected up to a ±300 V);
• 5 frequency inputs single-ended 1-150 V;
• 1 switch input.
• Internal temperature sensor 0/100 °C (accuracy ±0.5 °C)
• 4 open-drain outputs for on/off driving, each at 600 mA, each one is protected, and including clamping diodes (eg fan driving)
Controller area network (CAN)
The MD3 dashboard can be connected to other devices through programmable CAN port included (2.0A&B, 1Mbits/s). Other devices can be:
- ECU (Engine Control Unit);
- Analog inputs expansion module;
- Lambda Controller
System datasheet
• External power supply 9-28V;
• Computing power 100 MIPS;
• GPS module at 5 Hz keeping the almanac for 24 hours with system off, built-in GPS antenna and external antenna inlet;
• 2 GB memory;
• Real-time clock with rechargeable battery (2 months autonomy if switched off);
• 5 on-board LED’s. Each one has its own settings and intensity;
• 1 filtered USB 1.1 port (USB 2.0 compatible);
• 1 CAN 2.0b with bit rate up to 1 Mbps and filters. (for connecting to other devices such as Engine Control Unit or expansion modules for analog and digital channels);
• Setup or firmware update via USB;
• Serial port RS232, bit rates up to 250 kbps;
• Plug&play connector for connecting to original installation;
• Anodised aluminium case (IP68);
• Total weight: 600gr. |
